4. Unlatch the control-panel cover and move it aside
(Figure
22).
Figure 22
1. Control panel
5. Locate and remove the 2 knockout plugs from the top
of the control panel
Figure 23
1. Knockout plugs
6. Carefully cut and remove the decal material to expose
the control panel holes.
Note: Remove only the knockout plugs and decal
material for the required switches.
7. Deburr the newly exposed edges of the control panel.
8. Clean the control panel surface and affix the decal
around the exposed holes
2. Latch
(Figure
23).
2. Knockout plug locations
(Figure
24).
1. Decal
2. Float/power-down switch
(2-position switch)
9. Insert the switches into the appropriate mounting holes
(Figure
24).
Note: Position the flat portion of the switch toward
the operator.
10
Figure 24
3. Lift/lower switch
(3-position switch)