Table of Contents
Advertisement
13.3.16.
Safety Parameters(CR750/CR700)
You can set parameters of Robot Safety Option in the CR750/CR700 series robot controllers.
For details of these parameters, refer to the "Robot Safety Option manual" (BFP-A3372).
This function is available in CR750/CR700 controller software Ver.R6, S6 or later (robot safety option is needed).
The setting method of the safety parameters of the CR800 series robot controller is different. For details, refer to
"13.9 Parameters of Safety (CR800)".
These parameters cannot be set by the offline editing.
Double-click [Movement parameter] -> [Safety] under the [Parameter] item to be edited from the project tree.
13.3.16.1.
Enable Disable
You can set Enable / Disable of the safety monitoring function in Robot Safety Options, set the DSI signal, and
change the password.
You can reference explanations of the displayed parameters by clicking the [Explain] button.
After you change a parameter values, you can rewrite the parameter in the robot controller by clicking the [Write]
button.
The [CRC of parameter file output #] item is displayed in CR750/CR700 controller software Ver.R6b/S6b or later.
13-238
Figure 13-38 Safety parameter (Enable Disable)
13-238
Advertisement
Table of Contents
