Toshiba V Series Manual page 259

C-3 The parameter registration by ladder program and the
parameter registration by DeviceNet Wizard for TOSHIBA
Registration by the ladder program and registration by DeviceNet Wizard for TOSHIBA
must not exist together (The example:The node parameter is registerd by the ladder
program and the slave device parameter is registerd by DeviceNet Wizard for TOSHIBA).
If registration by both is intermingled, rewriting of the contents of registration etc. occurs
and there is a possibility that the allocation of slave device data to input/output data area
may become impossible.
D. Problem in old model DN311
The following restriction which was in old model DN311 is solved in DN311A.
Using the polling mode slave device which transmission data size from master device is
"0 bytes", when that slave device fails to communicate with DN311 due to some reason
(power of that slave device side turned OFF, connector removed, etc.), DN311 cannot
identify that slave device being malfunctioned.Even after the cause of the failure is
solved, no communication between that slave device and DN311 can be resumed.
E. DeviceNet Wizard for TOSHIBA
DeviceNet Wizard for TOSHIBA is software which works on Microsoft Windows 95/98/
NT4.0. The user can keep handy with the registration of the slave parameter to the
master module and the allocation of the slave data to master module input/output area by
graphical user interface like the figure below.
Please buy DeviceNet Wizard for TOSHIBA from our company. Product
code:TDW33E2SS
E
The personal computer in which DeviceNet Wizard for TOSHIBA is installed is connected
with the DeviceNet network and actual, various work is done. There are three kinds of
239
6F8C0903