Toshiba V Series Manual page 110

Chapter 4 Operating Procedures for the DN311 (Software)
4
90
(3) Description of operation
S controller
ASW RITE_DT
Output data
register area
ASW RITE_DT
Figure 4-20 Slave Data Output Function Block Data Output
(a) Use this function block when the DN311 is in run mode.
(b) The allocation confirmation (DN_INSTRUCT) function block mentioned above is
used inside this function block. Therefore, register the allocation confirmation
function block on the product list in advance.
(c) When REQ is TRUE, output data to the slave device specified in terms of node
and BS under management by the DN311 that is specified by CH, UNIT, and
SLOT is written from ASWRITE_DT (WDAT[0] to [5]) into the output data area
(polling or bit strobe) of the DN311, then DONE is turned TRUE.
(d) The data is written in the type of output data area selected by BS (which,
however, must be identical with that registered by slave parameter setting).
(e) Which of WDAT[0] to [5] will be an actual slave device output depends on the
slave device to be used. Refer to the slave device manual.
(f) Keep REQ TRUE till DONE becomes TRUE.
(g) If an error occurs, ERR and DONE are turned TRUE.
(h) Completion status is output to STATUS.
(i) This function block cannot be used in synchronous mode. For slave device
output in synchronous mode, use the batch slave input/output function block.
(j) If this function block is used in synchronous mode, ERR and DONE are turned
TRUE.
(k) This function block is compatible with slave devices having send data of up to 6
words (12 bytes) (or 4 words, i.e., 8 bytes, for bit strobe slave devices) allocated.
If slave devices have more than 6 words of send data allocated, use the input/
output data area batch access function block.
DN311
Polling output data
area
Bit strobe output
data area
model 3000 DeviceNet Module Manual (DN311/DN311A)
Slave device
Polling
Bit strobe