Fuji Xerox Versant 3100 Press Optional Units Manual page 13

1.
Remove jammed papers.

When Lamp E5 is Lit...........................................................................................................................................................p.13

When Lamp E6 is Lit...........................................................................................................................................................p.13

When Lamp E7 is Lit...........................................................................................................................................................p.14
Note
Solutions differ depending on where the paper jam occurs. Confirm the jammed area in the Error
Message area.
The code (E) on the upper-left part of the message indicates which error lamp on the top of the
machine is illuminating.
When Lamp E5 is Lit
(1) Open the cover on the top of the Bypass Tray, and
remove jammed papers and all papers loaded in the
Bypass Tray.
When two or more sheets of paper are loaded,
remove all the sheets from the Tray.
Important
(2) Close the cover.
(3) Fan the paper you removed and make sure all four
corners are aligned correctly. Then reload the paper.
If you have difficulty in removing jammed papers, open
the cover on the right side to remove the paper inside.
Refer For detailed information on paper jams inside the right side cover, refer to "1.2.2 Paper Jams inside
the Right Side Cover" (p.14).
When Lamp E6 is Lit
(1) Pull out the Tray 8 toward you until it stops.
Before pulling out the Tray, make sure no paper is
jammed inside the right side cover.
Important
(2) Remove jammed papers.
(3) Make sure the long-side and short-side paper guides are positioned to just touch the
paper, and then push the Tray into the machine.
Chapter 1 2nd High Capacity Feeder C1-DS
13