Recycling And Disposal; End User; Start-Up; Temporary Shutdown - Riello 7200/3F HV PLUS Series Installation, Operation And Maintenance Manual

Table of Contents

Advertisement

END USER

14 RECYCLING AND DISPOSAL

The device is primarily composed of:
carbon steel
PU (polyurethane)
PE (polyethylene)
ABS (acrylonitrile-butadiene-styrene)
PVC (polyvinyl chloride)
At the end of the device's useful life, these components must be separated and disposed of according to current regulations in the
country of installation.
END USER INSTRUCTIONS
Refer to the GENERAL SAFETY INFORMATION and PRECAUTIONS section for safety-related information.
END USER

15 START-UP

The heater commissioning must be performed by Technical As-
sistance Service personnel.
Under certain circumstances, such as after long periods of dis-
use, the user may need to re-start it without involving the Tech-
nical Assistance Service. Before doing so, perform the following
checks and operations.
− Check that the supply cocks in the domestic water circuit
are all open
− Switch the electricity supply ON at the mains power
switch and at control panel switch (if fitted).
RIELLO S.p.A.
Via Ing. Pilade Riello, 7
37045 - Legnago (VR)
www.riello.com
The manufacturer strives to continuously improve all products. Appearance, dimensions, technical specifications, standard equipment
and accessories are therefore liable to modification without notice.
Material
structural work
water connection washers

16 TEMPORARY SHUTDOWN

To reduce to the environmental impact and save energy, in case
of brief absences, week-ends, short trips, etc., and with exter-
nal temperatures above 0°C, set the heater temperature control,
where available, to the minimum value.
9
If the temperature to which the heater is exposed can fall
below 0°C (frost hazard), perform the operations described
in paragraph "Preparing for extended periods of disuse".

17 PREPARING FOR EXTENDED PERIODS OF DISUSE

If the storage cylinder is not going to be used for an extended
period of time, ask the manufacturer's Technical Assistance Ser-
vice to make the system safe.

18 EXTERNAL MAINTENANCE

Clean the outside of the storage cylinder with a soft cloth
damped in soapy water.
0
Do not use abrasive products, petrol or triethylene.
End user
8
Component
insulation
covers
lining

Advertisement

Table of Contents
loading

This manual is also suitable for:

7200/3f - 800 hv plus7200/3f - 1000 hv plus7200/3f - 1500 hv plus7200/3f - 2000 hv plus7200/3f - 3000 hv plus20136273 ... Show all

Table of Contents