Omron NX Series User Manual page 98

4 Installation and Wiring
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
3
Remove the flat-blade screwdriver from the release hole.
After you make a connection, make sure that the twisted wire or the solid wire is securely connected
to the terminal block.
4 - 38
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
2
Twisted wire/Solid wire
3
NX-series System Unit User's Manual (W523)