Omron NX Series User Manual page 100

4 Installation and Wiring
Removing Wires
Use the following procedure to remove the wires from the terminal block.
The removal method is the same for ferrules, twisted wires, and solid wires.
1
Press the flat-blade screwdriver diagonally into the release hole.
Press at an angle of 10° to 15°.
If you press in the screwdriver correctly, you will feel the spring in the release hole.
2
Leave the flat-blade screwdriver pressed into the release hole and pull out the wire.
3
Remove the flat-blade screwdriver from the release hole.
4 - 40
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Flat-blade screwdriver
1
10 to 15°
2
Wire
3
NX-series System Unit User's Manual (W523)