Key Functions - York YKFE12BXEXBH-RX Installation And Owner's Manual

Key Functions

1. Auto Mode:
Press the MODE button when
The mode of operation, COOL or FAN, will be
automatically determined by room temperature.
2. Cool Mode:
The air conditioner is designed for cooling when
ambient temperature is 18-43°C.
Press the MODE button when
Set the desired temperature with the TEMP+/-.
AUTO FAN SPEED is automatically determined
HIGH, MEDIUM or LOW speed according to the
difference between room and pre-set temperature.
3. FAN SPEED Mode:
(1) In modes other than Fan, the air speed can be
adjusted in order: Low, Medium, High and Auto.
Low Medium High
(2) In FAN mode, the "Auto" is disabled.
4. Dry Mode:
Press the MODE button when
speed is pre-set at auto speed.
5. Louver Selection:
1
Indicator
4 2
3
(2) When you firstly press
deflectors simultaneously flash. Press the button
again to switch the display of air deflector icon.
Circulation mode of the four icons: All→1→2→3→4.
(3) When selected louver
to adjust the angle of the louver. The icon will stop
flashing in five seconds, the setting is confirmed.
(4) Angle of up-down swing.
1
2
3
4
5
indicates.
indicates.
Auto
indicates. The Fan
, the icons of four air
, flashes,press swing
6. TURBO/QUIET
(1) Press "TURBO/QUIET", the LCD displays
TURBO Mode is set.
Press "TURBO/QUIET" again, the controller LCD
displays the Quiet Mode is set. Press"TURBO/
QUIET" again to exit the setting of TURBO/QUIET.
Resume set air speed.
(2) This function is only enabled in Cool mode.
7. TIMER
Press TIMER, the
Press TIME+/TIME- to
Timer On
select the desirable time.
Press SET to confirm.
Press TIMER, the
PressTIME+/TIME- to
Timer Off
select the desirable time.
Press SET to confirm.
Intelligent TIMER for setting both
Timer
ON-OFF times at one time.
Press TIMER, the
Timer
Press TIME+/TIME- to
On → Off
select the desirable start time.
On ← Off
Press TIMER, the
Press TIME+/TIME- to
select the desirable stop time.
Press SET to confirm.
Press TIMER button again to
EXIT
cancel timer setting and exit.
8. High rise Mode
(When the indoor unit installation is with high
ceiling)
To enable High Rise option, set temperature at
30°C under Cooling at high Fan speed, then press
the Sleep button 5 times within 2 seconds. The
High Rise mode is enabled. Temperature and fan
speed can now be adjusted back to desired setting.
To cancel the High Rise mode, set temperature
at 30°C under Cooling at High Fan Speed, press
Sleep button 5 times within 2 seconds. The High
Rise mode is cancelled.
ON
blinking.
OFF
blinking.
ON blinking.
ON
blinking.
5