Nautilus T618 Service Manual page 45

13. Using a 6mm hex wrench, remove the
hardware from the Left Upright. Be prepared
to support the Upright when the hardware is
removed.
14. Using a 6mm hex wrench, remove the
hardware from the Right Upright. Slightly
remove the Right Upright from the Base
Assembly exposing the Input/Output (I./O)
Cables. Disconnect the I/O Cables and remove
the Right Upright.
Note: Do not crimp cables.
15. Make sure there is sufficient space to tilt the walking deck onto the left
side and then onto the Walking Belt. The Walking Belt should rest on the
ground.
Keep a minimum clearance behind the machine of 79" (2 m)
and 24" (0.6 m) on each side. This is the recommended safe
distance for access, movement and emergency dismounts
from the machine.
Note: THE FOLLOWING STEP MAY REQUIRE A SECOND PERSON.
16. With the assistance of at least a second person, tilt the Base Assembly
onto the left side, and then onto the Walking Belt.
Be sure the area is clear around the Base Assembly before
flipping it. Do not grasp the Walking Belt since it can abruptly
move.
X2
45
X2