Engineering Mode; To Access The Engineering Mode; Mcb Calibration Procedure - Nautilus T618 Service Manual

ENGINEERING MODE

ENGINEERING MODE is a sub-menu from the CONSOLE SETUP MODE. Most of the options contained within the Engi-
neering Mode are for Service Technicians and should not need to be accessed by a user.

To access the Engineering Mode:

1. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Right arrow button for
about 5 seconds to go into the Console Setup Mode. The Console display will show the Date prompt with the current
setting.
Note: Push PAUSE/STOP to exit the Console Setup Mode and return to the Power-Up Mode screen.
2. Push the OK button 4 times until the Console displays the TOTAL RUN HOURS screen.
3. Push and hold down the PAUSE/STOP button and Right arrow button for about 5 seconds to go into the Engineering
Mode. The Console display will show the current Firmware Version.
Prompts displayed by the Console (in order using the Up arrow button) :
A. Firmware Version ( "xxxxxxxxxxRxx" )
B. RESET CONSOLE
C. RUN LCD TEST
D. RUN LED TEST
E. RUN BTN TEST
F. RUN BEEP TEST
G. RUN MCB TEST
H. RUN HR TEST
I. RUN ESTOP TEST
J. RUN MCB CAL ( see procedure below )
K. RESET MFG NVM
L. DEBUG TERMINA
M. ENTER MFG TES

MCB Calibration Procedure

1. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Right arrow button for
about 5 seconds to go into the Console Setup Mode. The Console display will show the Date prompt with the current set-
ting.
2. Push the OK button 4 times until the Console displays the TOTAL RUN HOURS screen.
3. Push and hold down the PAUSE/STOP button and Right arrow button for about 5 seconds to go into the Engineering
Mode. The Console display will show the current Firmware Version.
4. Push the Down arrow button 4 times until the Console displays "RUN MCB CAL".
Be sure the area around the Treadmill is clear of all bystanders, children and pets. Be sure there is nothing
on or under the Walking Belt, or near the Treadmill.
5. With the area clear, push the OK button. The calibration procedure will begin by automatically moving the Walking Belt
and lifting the Deck through the full range of incline motion.
Be sure not to touch or allow anyone else to touch the machine while calibration is occurring.
6. When calibration is complete, the Console will display "done" for a few seconds, and then return to the "RUN MCB
CAL" option.
7. Flip the power switch to OFF. Calibration is now complete for the machine.
( Item J of Engineering Mode )
28