Nautilus T618 Service Manual page 43

To reduce the risk of electrical shock or unsupervised usage of the equipment, always unplug the power cord from the
!
wall outlet and wait 5 minutes before cleaning, maintaining or repairing this machine. Place the power cord in a secure
location.
1. Unplug the power cord from the machine and wait 5 minutes. Place the
power cord in a secure location.
2. Using a standard screwdriver, gently lift and release the Handlebar
Shrouds from the Console Assembly.
3. Using a #2 Phillips screwdriver, remove the 13 indicated screws from
Console Backing. Be sure to support the Console Backing when removing
the hardware.
4. From the Right Upright, disconnect the Grounding, Input/Output,
Remote Speed Control Cables. Do not allow the Grounding and I/O Cable
to fall into the Right Upright. Secure it with a Zip-Tie, rubber band or piece
of wire.
Note: Do not crimp the Cables.
5. Using a 6mm hex wrench, remove the indicated hardware from the
Right Upright.
Handlebar Shrouds
43
Right Upright