Power Up / Idle Mode; Initial Setup - Nautilus T618 Owner's Manual

Hide thumbs Also See for T618:
Table of Contents

Advertisement

• If there is an emergency, pull out the Safety Key to shut off the power to the Belt and Incline Motors. This will quickly
belt and pause the program.
7.
Push the USER button to select the desired User for the workout.
9.
With your desired workout shown, push the OK button.
10. The Console will ask a series of questions to customize the workout. When the Console displays the "READY ?"
prompt, push the START button. The Console will display "RAMPING UP" as the Walking Belt gets up to speed. Be sure
to carefully step onto the walking belt.
The belt will only move after a 3 second, audible beep countdown.
Always use the handlebars to step on or off the treadmill, or when the incline or speed change.
If the Sound has been muted, the Console will display the "AUDIO OFF" prompt for a few seconds.
To prevent injury, stand on the Foot Platforms before you start the machine or end a workout. Do not
dismount the machine by standing on the moving Walking Belts and exiting off the rear of the unit (or
machine) .
Note: Your treadmill comes equipped with a durable, high quality walking belt designed to provide many hours of
reliable service. The walking belt on a treadmill that has not been operated for a length of time, either in factory
of the front and rear rollers. This is a common occurrence and does not indicate a problem with your machine. After
the treadmill has been used for a short period of time the thumping noise will discontinue. The amount of time will vary
depending on the temperature and humidity of the environment where the treadmill is placed.
Power-Up / Idle Mode
The Console will enter
Safety Key is properly installed.
Note:
is installed, the START button will need to be pushed again to begin the selected Workout.
Auto Shut-Off (Sleep Mode)
while in Sleep Mode.
To disconnect, turn all controls to the off position, then remove plug from outlet.

Initial Setup

2.
Push OK to set.
4.
Push OK to set.
/ Idle Mode if it is plugged into a power source, the Power Switch turned on, and the
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents