Power Up / Idle Mode; Initial Setup - Nautilus T626 Assembly Manual / Owner's Manual

7. Push the USER button to select the desired User for the workout.
8. S elect your workout using the PROGRAMS button and the Decrease/Increase buttons.
9. With your desired workout shown, push the OK button.
10. The Console will ask a series of questions to customize the workout. When the Console displays the "READY ?"
prompt, push the START button. The Console will display "RAMPING UP" as the Walking Belt gets up to speed. Be
sure to carefully step onto the walking belt.
The belt will only move after a 3 second, audible beep countdown.
Always use the handlebars to step on or off the treadmill, or when the incline or speed change.
If the Sound has been muted, the Console will display the "AUDIO OFF" prompt for a few seconds.
To perform an emergency dismount, grab onto the Front or Side Handlebars and safely step onto the Side
Foot Platforms. Bring the Walking Belt to a stop and carefully step off the machine.
Note: Your treadmill comes equipped with a durable, high quality walking belt designed to provide many hours of reli-
able service. The walking belt on a treadmill that has not been operated for a length of time, either in factory packaging
or after assembly, can exhibit a "thumping" noise when started. This is due to the belt taking on the curve of the front
and rear rollers. This is a common occurrence and does not indicate a problem with your machine. After the treadmill
has been used for a short period of time the thumping noise will discontinue. The amount of time will vary depending on
the temperature and humidity of the environment where the treadmill is placed.
Power-Up / Idle Mode
The Console will enter Power-Up / Idle Mode if it is plugged into a power source, the Power Switch turned on, and the
Safety Key is properly installed.
Note: If the Safety Key is not installed, the machine will allow the User to perform all activities except to activate the
Walking Belt. The Console will display the reminder to insert the Safety Key ( " + SAFETY KEY" ). Once the Safety key
is installed, the START button will need to be pushed again to begin the selected Workout.
Auto Shut-Off (Sleep Mode)
If the Console does not receive any input in approximately 5 minutes, it will automatically shut off unless in Demonstration
mode. The LCD display is off while in Sleep Mode.
Push any button to start (wake up) the Console. If your machine is in Demonstration mode, hold down the PAUSE/STOP
button and Decrease button together for 3 seconds.
Note: The Console does not have an On/Off switch.
To disconnect, turn all controls to the off position, then remove plug from outlet.

Initial Setup

During the first power-up, the Console should be set up with the date, time, and the preferred units of measurement.
1. D ate: Push the Increase/Decrease buttons to adjust the currently active value (flashing). Push the Left/Right buttons
to change which segment is the currently active value (month / day / year).
2. Push OK to set.
3. T ime: Push the Increase/Decrease buttons to adjust the currently active value (flashing). Push the Left/Right buttons
to change which segment is the currently active value (AM or PM / hour / minute).
4. Push OK to set.
5. Units of Measurement: Push the Increase/Decrease buttons to adjust between "MILES" (Imperial English) or "KM"
(metric).
6. Push OK to set. The Console goes to the Power-Up Mode screen.
34