JRC JMA-3400 Series Instruction Manual page 10

FIRST-AID TREATMENTS
9． When to stop cardiopulmonary resuscitation (CPR)
a) When the injured or ill person has been handed over to the
emergency services
b) When the injured or ill person has started moaning or breathing
normally, lay him/her on his/her side in a recovery position and
wait for the arrival of emergency services.
10． Arrival and preparation of an AED
a) Place the AED at an easy-to-use position.
If there are multiple first-aiders, continue
CPR until the AED becomes ready.
b) Turn on the power to the AED unit.
Depending on the model of the AED, you
may have to push the power on button, or
the AED automatically turns on when you
open the cover.
c) Follow the voice prompts of the AED.
11． Attach the electrode pads to the injured or ill person's bare chest
a) Remove all clothing from the chest, abdomen, and arms (male or female).
b) Open the package of electrode pads, peel the pads off and
securely place them on the chest of the injured or ill person, with
the adhesive side facing the chest. If the pads are not securely
attached to the chest, the AED may not function. Paste the pads
exactly at the positions indicated on the pads, If the chest is wet
with water, wipe dry with a dry towel and the like, and then paste
the pads. If there is a pacemaker or implantable cardioverter
defibrillator (ICD), paste the pads at least 3cm away from them. If a
medical patch or plaster is present, peel it off and then paste the
pads. If the injured or ill person's chest hair is thick, paste the pads
on the chest hair once, peel them off to remove the chest hair, and
then paste new pads.
c) Some AED models require to connect a connector by following
voice prompts.
d) Do not put child pads on adults (older than 8 years).
12． Electrocardiogram analysis
a) The AED automatically analyzes electrocardiograms. Follow the
voice prompts of the AED and ensure that nobody is touching the
injured or ill person while you are operating the AED.
b) On some AED models, you may need to push a button to
analyze the heart rhythm.
13． Electric shock (defibrillation)
a) If the AED determines that electric shock is needed, the voice
prompt saying, "Shock is needed" is issued and charging starts
automatically.
b) When charging is completed, the voice prompt saying, "Push the
shock button" is issued and the shock button flashes.
c) The first-aider must get away from the injured or ill person, make
sure that no one is touching him/her, and then press the shock
button.
d) When electric shock is delivered, the body of the injured or ill
person may jerk.
viii
Turn on the power.
Press the shock button.