Show Mgc List - Avaya G250 Reference

CLI Commands
Related commands - Media gateway controller
clear mgc list, session,
icc-monitoring,
Related commands - Device status
set utilization cpu,
show restart-log,
voltages, test led

show mgc list

Use the show mgc list command to display the list of available Media Gateway Controllers
and their IP addresses.
On the G250, the show mgc list command also shows whether SLS survivability is enabled
or disabled. If SLS is enabled, the following message appears at the end of the MGC list:
survivable-call-engine
If SLS is disabled, the following message appears at the end of the MGC list:
survivable-call-engine
Note:
SLS is not supported by the G350 or the G250-BRI.
Note:
Syntax
show mgc list
User level
read-only
Context
general
Example
To display the list of media gateway controllers:
G350-001(super)# show mgc list
CONFIGURED MGC HOST
---------------------
135.8.48.220
135.34.54.2
149.49.70.230
652 Avaya G250 and Avaya G350 CLI Reference
set icc-monitoring,
show mediaserver, show mgc list
show faults, show mg
show status, show system,
disabled
set mediaserver, set mgc
list_config, show mm,
show temp, show
list, set reset-times,
show module, show recovery,
timeout, show utilization,
show
show