Interface Usb - Avaya G250 Reference

interface usb

Use the interface usb command to enter configuration context for the usb interface. Use
the no form of the command to reset the usb interface settings to their factory defaults.
Note:
This command is not supported by the G250.
Note:
The usb interface always exists, but is disabled by default. Use the no shutdown command to
enable the interface.
The default settings for the usb interface are:
Interface status
IP address
Netmask
timeout
PPP speed
Async modem-init-string
Syntax
[no] interface usb
User level
read-write
Context
general
Example
To enter the USB interface context:
G350-???(super)# interface usb
G350-???(super-if:USB-Modem)#
Related commands - IP interface configuration
description (interface),
serial, interface
broadcast-address, load-interval,
Related commands - Modem configuration
async modem-init-string,
DOWN
10.3.0.3
255.255.255.0
no timeout
38400 bps
"AT S7=45 S0=2 L1 V1 X4 &c1 E0 Q0"
interface Console,
tunnel, interface usb,
show ip interface brief
interface Console,
interface FastEthernet,
interface vlan, ip address,
ppp chap-secret
Alphabetical listing of CLI commands
interface Loopback,
ip admin-state, ip
Issue 1.1 June 2005
interface
217