Using The Probe - Bosch Electric Range with Magnetic Control Knob and European Convection Use And Care Manual

To Check the Cooking Time and
Stop Time After a Delay Has Been
Set
Setting the Sabbath Feature
Using the Probe (some
models)
Setting the Probe
Changing the Oven Temperature
When Using the Probe
Changing the Probe Temperature
1. Press Time.
2. Turn knob to BAKE END or BAKE TIME.
3. Press Time.
See "Set the Sabbath Feature" on page 13.
This section explains how to operate the probe. See "The Probe (some models)"
on page 24 for guidelines, tips and suggestions.
The probe can be used to determine the internal doneness or the "END" tempera-
ture of many foods, especially meats and poultry.
The temperature range for the probe is 135°F to 200°F (57°C to 93°C). Oven tem-
perature can be set for 100°F up to 450°F (38°C up to 232°C).
1. Prepare meat and place in roasting pan (or on rack in roasting pan as recipe
specifies). Insert the probe into the meat. See "Inserting the Probe" on
page 24 for detailed instructions. Make sure the probe is not touching gristle,
fat, bone, the roast rack or the pan.
Note: Do not connect to probe receptacle until probe tip is properly inserted into
meat.
2. Place roasting pan with meat in cold oven on recommended oven rack. Plug
probe into the probe receptacle. The probe symbol will appear in display.
Note: The probe temperature can only be set when the probe is installed in the
oven.
3. Press COOKING MODE and select BAKE, CONVECTION BAKE or CON-
VECTION ROAST.
4. Press START. The default oven temperature will appear.
5. Turn knob to change oven temperature if necessary.
6. Touch START.
7. Turn knob to set the probe temperature (desired end temperature of the food).
8. Press START.
The chosen oven temperature is displayed in the upper right hand corner of the
display.
The probe temperature is displayed in the center to the left of the cooking mode. It
starts at 80 degrees and increases in 5°F increments until the chosen probe tem-
perature is reached.
The oven is preheated when the beep signals once.
When the set probe temperature is reached, END appears in display and oven
turns off.
1. Touch TEMPERATURE. Oven temp will flash in the display.
2. Turn the knob to desired temperature and press START twice.
1. Touch TEMPERATURE. The oven temperature will flash.
2. Press start and PROBE TEMP will flash.
3. Turn the knob to desired temperature and press START again.
Note: Always remove probe from oven when cooking is complete. The probe
symbol will remain in the display until the probe is removed. Do not leave probe
Operation - Oven
English 19