Panasonic CF-T2 Series Reference Manual page 57

Security Measures
When you do not want your computer to be used without
permission
6
Re-enter your password at [Confirm New Password] and press the
Enter
key.
To disable the User Password
Press only the Enter key.
7
At [Setup Notice], press the
When you do not want the User Password enabled or changed without
permission:
Set [User Password Protection] using the following procedure:
A
Using the key and the
Enter key.
B Using either the
key.
8
F10
Press the
When [Password on boot] is set to [Enable], it is impossible to start the computer without
knowing the password.
NOTE
You cannot set [Password on boot] without setting the Supervisor Password. Set the
Supervisor Password if you have not done so (
When starting up the Setup Utility, the password input screen will be displayed if a
Supervisor Password or User Password has been set, even if [Password on boot] is
set to [Disable].
Enter
key.
key, select [User Password Protection] and press the
key, select [Protected] and press the Enter
key or the
key and select [Yes], then press the
57
Enter
key.
page 54).