Panasonic CF-T2 Series Reference Manual page 154

Problems with Wireless LAN
Access point is not detected
Check that the access point is powered on.
Shorten the distance between the computer and the access point, and try the detection
again.
It may take some time before the access point is displayed in [Available Networks]. Wait
for a moment.
Confirm the following settings:
• [Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [Wireless LAN] is set to [Enable]. (
• Wireless device off:
Confirm that the
If the / /
[Wireless On] is selected in [Intel PROSet/Wireless] screen. (
Confirm whether the Intel
menu.
[start] - [Control Panel] - [Add or Remove Programs].
If it has not been installed, input [c:\util\drivers\wlan\proset\iproinst.exe EoU=False] in
[start] - [Run] to install.
Confirm that the
the wireless LAN is off. Click
Even with the wireless LAN turned on, 802.11a may be disabled. To use 802.11a, use
the following procedure to enable it.
A
Click the
B
In the menu, click [Enable 802.11a].
If [Disable 802.11a] is displayed, this means it is currently enabled.
This computer uses channels 1 through 11
being used by the access point.
*1
In the case of wireless communications, the frequency band being used can be divided into
segments, so that different communications can be conducted on each band segment. A "Channel"
refers to the individual frequency bandwidth divisions.
/ / icon is displayed on the notification area.
icon is not displayed on the notification area, confirm that
®
PROSet/Wireless Software is installed using the following
icon is displayed on the notification area. If the
and click [Enable Wireless LAN].
icon on the notification area.
*1
when using 802.11b/g. Check the channel
154
page 114)
page 105)
is displayed,