To Replace The Transmission Control (Lc 141Vli) - Husqvarna LC 141VLi Workshop Manual

14. Remove the screw to the height adjustment lever.
15. Remove the large e-clip (A) on the inside of the
height adjustment lever with a screwdriver.
16. Remove the large e-clip (B) in front of the washer
with a screwdriver.
B
17. Pull the bearing cover off on both sides of the
transmission shaft to separate the transmission from
the wheel axle.
18. Replace with a new transmission in the opposite
sequence.
Note: Make sure that the large e-clips on each end of the
transmission shaft are put back in front of the washer
and height adjustment lever.
19. Tighten the screws and nuts with a torque of
5-10 Nm.
Note: The rear axle fixing plates have different colors to
make sure that they are not mixed up. Attach the black
rear axle fixing plates on the outer side of the chassis.
4.9 To replace the transmission
control (LC 141VLi)
1. Remove the motor cover and disconnect the cables.
2. Disconnect the cable between the transmission
A
3. Remove the 3 screws that hold the transmission
4. Replace with a new transmission control in the
5. Tighten the screws with a torque of 1.5-2 Nm.
Repair instructions LC 141VLi/LC 141Li
WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
See "4.3 To remove and attach the motor cover"
control and the battery connection harness.
control and lift it out.
opposite sequence.
English – 17