To Replace The Battery Connection Harness - Husqvarna LC 141VLi Workshop Manual

Repair instructions LC 141VLi/LC 141Li
4. Remove the 12 screws that hold the motor cover.
5. Put the product back in upright position.
6. Lift off the motor cover. Disconnect the cables to fully
remove the motor cover.
7. To put the motor cover back, first connect the cables.
8. Put the product down on its side.
9. Tighten the screws in the motor cover and the black
plastic cover (LC 141VLi) with a torque of 1.5-2 Nm.
14 – English
4.4 To replace the battery connection
harness
WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
1. Remove the motor cover and disconnect the cables.
See "4.3 To remove and attach the motor cover"
2. Disconnect the cables (A) between the battery
connection harness and the transmission control
(LC 141VLi)/relay.
3. Disconnect the 2 red cables (B) between the battery
connection harness and the pressing plate of the
safety key switch.
4. Remove the 2 screws and lift the battery connection
harness out.
5. Replace with a new battery connection harness in
the opposite sequence.
6. Attach one of the red cables on the battery
connection harness, to the right socket on the
pressing plate of the safety key switch.
7. Attach the other red cable on the battery connection
harness, to the left socket on the pressing plate of
the safety key switch.
8. Tighten the screws with a torque of 1.5-2 Nm.
A
B