To Replace The Relay (Lc 141Li); To Replace The Handle - Husqvarna LC 141VLi Workshop Manual

Repair instructions LC 141VLi/LC 141Li

4.10 To replace the relay (LC 141Li)

WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
1. Remove the motor cover and disconnect the cables.
See "4.3 To remove and attach the motor cover"
2. Disconnect the cable between the relay and the
battery connection harness.
3. Remove the 2 screws that hold the relay and lift it
out.
4. Replace with a new relay in the opposite sequence.
5. Tighten the screws with a torque of 1.5-2 Nm.

4.11 To replace the handle

WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
1. Remove the motor cover. See "4.3 To remove and
attach the motor cover".
2. Remove the 2 screws from the cable entry,
3. Remove the bracket and carefully lift out the cables.
4. Disconnect the cables to the handle.
18 – English
5. Pull the cables from the hook at the bottom of the
handle.
6. Remove the cable holders.
7. Remove the knobs and bolts.
8. Replace with a new handle in opposite sequence.
9. Tighten the screws in the cable entry with a torque of
1.5-2 Nm.