To Replace The Transmission (Lc 141Vli) - Husqvarna LC 141VLi Workshop Manual

Repair instructions LC 141VLi/LC 141Li
4.8 To replace the transmission
(LC 141VLi)
WARNING: Before you start, turn the safety
key to 0, remove safety key, remove the
battery and wait a minimum of 5 seconds.
1. Remove the wheels from the rear axle.
2. Remove the e-clip in front of the gear with a
screwdriver.
3. Remove the spring washer from the wheel axle.
4. Pull the gear off.
5. Pull the wheel cover off.
6. Remove the e-clip on the transmission shaft with a
screwdriver.
7. Remove the screw that holds the rear end of the
connecting rod.
8. Carefully lift off the connecting rod.
16 – English
9. Remove the 2 screws from the guide plate.
10. Remove the 2 bolts and nuts from the rear axle fixing
plates on the left side of the product.
11. Remove the 2 bolts and nuts from the rear axle fixing
plates on the right side of the product. Move the
cutting height lever to get access to the screws.
12. Tilt the transmission and rear axle to get access to
the connection cable.
13. Disconnect the cable and lift the transmission and
rear axle out.