Videojet Decoder 3000 Configuration - Bosch MIC Series Tech Note

Configuration of MIC IP 7000 HD – VIDEOJET decoder 3000 – for integration with analog CCTV | 13/18
4.4 VIDEOJET decoder 3000 Configuration
This section describes the steps to convert HD video from the MIC IP 7000 HD to an analog video
signal using the MIC IP 7000 HD camera with the VIDEOJET decoder 3000. The following will focus
on the camera decoder configuration from its web interface. For complete configuration details of the
VIDEOJET decoder, refer to the VIDEOJET installation manual [2].
Use the Web Interface or the Configuration Manager to set the VIDEOJET decoder 3000
Point the web browser to the camera IP address (when the VIDEOJET is reset to factory defaults, the
IP address of the decoder is 192.168.0.1).
1. Go to the SETTINGS page to start the configuring the unit.
Figure 10: Decoder SETTINGS menu.
Bosch Security Systems Version 1.3 | September 2015