Displayed Messages; Technical Data; Tips For Energy Saving - DeLonghi ECAM23.46 Series Instructions For Use Manual

1. Extract the tank (A10) and exhausted filter;
2. Press the P button (B4) to enter the menu;
3. Turn the selection dial (B2) (fig. 9) until "Install filter *"
appears on the display (B1);
4. Press the button (B9);
5. "Disable?" appears on the display;
6. Press the button to confirm and the
(B5) to exit the menu.

15. TECHNICAL DATA

Voltage: 220-240 V~ 50/60 Hz max. 10A
Absorbed power:
Pressure:
Max. water tank capacity:
Size LxDxH:
Weight (depending on models):
Max. beans container capacity:

16. DISPLAYED MESSAGES

DISPLAYED MESSAGE
FILL TANK
EMPTY GROUNDS CONTAINER The grounds container (A15) is full.
INSERT GROUNDS CONTAINER After cleaning, the grounds container (A15)
ADD PRE-GROUND COFFEE
button
1450W
1,5MPa (15 bars)
1.8 l
240x430x350 mm
9.7 / 9.4 kg
250 g
POSSIBLE CAUSE
Insufficient water in the tank (A10).
The tank (A12) is not correctly in place.
has not been replaced.
The "pre-ground coffee" function has been se-
lected without placing any pre-ground coffee
in the funnel (A6).
De'Longhi reserves the right to modify the technical specifica-
tion and styling of its products at any moment, without com-
promising their functionality and quality.

15.1 Tips for Energy Saving

• To reduce energy consumption, after delivering one or
more beverages, remove the container (D) or accessories.
• Set auto-off to 15 minutes (see section "6.6 Auto-off"):
• Enable Energy Saving (see section "6.7 Energy saving");
• When requested by the machine, perform the descaling
cycle.
REMEDY
Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (fig. 3).
Insert the tank correctly and press as far as it
will go (fig. 3).
Empty the grounds container and drip tray
(A19), clean and replace (fig. 25). Important:
when removing the drip tray, the grounds con-
tainer MUST be emptied, even if it contains few
grounds. If this is not done, when you make
the next coffees, the grounds container may fill
up more than expected and clog the machine.
Remove the drip tray (A19) and insert the
grounds container.
Place pre-ground coffee in the funnel (fig. 12)
or deselect the "pre-ground" function.
18
→