DeLonghi ECAM23.46 Series Instructions For Use Manual page 20

DISPLAYED MESSAGE
GROUND TOO FINE ADJUST
MILL
DESCALE
LESS COFFEE
FILL BEANS CONTAINER
INSERT INFUSER ASSEMBLY
INSERT TANK
GENERAL ALARM
REPLACE FILTER
SET DIAL TO CLEAN
INSERT WATER SPOUT
INSERT MILK CONTAINER
WATER CIRCUIT EMPTY FILL
WATER CIRCUIT
HOT WATER
Confirm?
POSSIBLE CAUSE
The grinding is too fine and the coffee is deliv-
ered too slowly or not at all.
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing the flow.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel (A6) is clogged.
The infuser (A12) was not replaced after
cleaning.
The tank (A10) is not correctly in place.
The inside of the appliance is very dirty.
The water softener filter (C4) is spent.
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
The hot water spout (C6) is not inserted or is
inserted incorrectly.
The milk container (D) is not inserted correctly. Insert the milk container (fig. 20) as far as it
The water circuit is empty.
REMEDY
Repeat coffee delivery and turn the grind-
ing adjustment dial (A2) (fig. 11) one click
clockwise towards 7 while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click (see section "8.4 Adjusting
the coffee mill"). If the problem persists, make
sure the water tank (A10) is fully inserted.
Insert the hot water spout in the appliance and
deliver a little water until the flow becomes
regular.
The descaling procedure described in section
"12. Descaling" needs to be performed.
Select a milder taste by pressing the dial
(B6) (fig. 8) or reduce the quantity of
pre-ground coffee.
Fill the beans container (A7) (fig. 12).
Empty the funnel with the help of the brush
(C5) as described in section "11.8 Cleaning the
pre-ground coffee funnel".
Insert the infuser as described in section "11.9
Cleaning the infuser".
Insert the tank correctly and press as far as it
will go (fig. 3B).
Clean the inside of the appliance thoroughly,
as described in section "11. Cleaning". If the
message is still displayed after cleaning, con-
tact a customer service centre.
Replace the filter or remove it as described in
section "14. Water softener filter"
Turn the froth adjustment dial (D1) to the
CLEAN position.
Insert water spout as far as it will go.
will go.
Press
water spout (C6) until it flows out normally. If
the problem persists, make sure the water tank
(A10) is fully inserted.
19
(B9) to deliver water from the hot