Rear Bumper; Rear Covering - Porsche 911 GT3 Cup MR Gen. II Technical Manual

5.8 Rear Bumper

► The weight-optimized rear bumper is made of carbon fiber composite and is designed for fastening
the rear diffuser.
The inside of the rear trim is covered with a heat-resistant film. Dama-
ATTENTION
ge to this film must be repaired immediately with the appropriate ma-
terial. Failure to observe this can result in heat damage to the rear
bumper.
The standard rain light of the 911 GT3 Cup Gen.II must be retained for
NOTE
the new rear bumper.
The corresponding tightening torques can be found in the detailed
assembly instructions. This is available for download from the Manthey
Racing website.
Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
BODY EXTERIOR | Rear Bumper
57
Home