Porsche 911 GT3 Cup MR Gen. II Technical Manual page 104

Lookup Tables - Light_Function_right
►Similar to the settings of the "Light_Functions_left", these settings for the LEDs of the right main
headlight can be adjusted via the "Light_Functions_right" tab.
Open the tab "Light_Function_right"
Procedure for setting the Color ID / display of the Error Monitor when crossing the timing signal for
the LEDs of the left main headlight:
Enter in Row 0 the Value 1, if the Color ID should be displayed after crossing beacon signal

Enter in Row 0 the Value 2, if the Error Monitor should be displayed after crossing beacon signal

Procedure for setting the Color ID when the Pit Speed Limiter is active.
Enter in Row 1 the Value 1, if the Color ID is to be activated when the Pit Speed Limiter is acti-

vated (in the pitlane)
If the preset values are changed, the setup with the new values must
NOTE
be transferred to the ICD using the "Send Setup" button. All data still
stored on the ICD will be lost when the changed setup is transferred!
Carry out a data backup beforehand!
It is advisable to configure the LEDs of one headlight with the desired
NOTE
Color ID and the LEDs of the other headlight to display of any error
entries (Alarms / Error Monitor).
Version V2, 08/2020
The following alarms/errors can be displayed via the LEDs of the headlights when the
beacon signal is crossed. The display then takes place with red glowing LEDs. There is no
differentiation/specification of the alarm / error;
Porsche 911 GT3 Cup MR Gen.II
ELECTRICS | Intelligent Color Display (ICD)
 Alternator
 Crankcase Pressure  Water Pressure
 Oil Level high  Gearbox Oil Temperature
 Oil level low  Water Temperture
 PCU  Oil Temperature
 Fuel Pressure  Battery Voltage
 Oil Pressure  Water Level
104
Home