Profinet; Outline; Initial Setting For Profinet - Mitsubishi Electric 800 Series Instruction Manual

2.12

PROFINET

2.12.1 Outline

When the PROFINET communication operation is performed through the Ethernet connector on the inverter, data transmission
is enabled for parameters, command data, and feedback data between a master and slaves.
 Communication specifications
The communication specification varies depending on the specification of the master.
Item
Category 100BASE-TX
Transmission speed 100 Mbps (10 Mbps is not supported.)
Maximum number of
No upper limit on the same Ethernet network
branches
Number of cascade
Maximum: 2
connection stages
Ethernet cable
Connection cable (IEEE 802.3 100BASE-TX compliant cable or ANSI/TIA/EIA-568-B (Category 5e)
compliant shielded 4-pair branched cable)
 Operation status LEDs
LED name Description
NS Communication status
MS Inverter status
LINK1 Connector for communication (PORT1) status
LINK2 Connector for communication (PORT2) status
 GSD file
A GSD file is available for download.
Mitsubishi Electric FA Global Website:
www.MitsubishiElectric.co.jp/fa
For details, contact your sales representative.
NOTE
• The GSD file is used in configuration software. To install the GSD file properly, refer to the instruction manual of your
configuration software.

2.12.2 Initial setting for PROFINET

Use the following parameters to perform required settings for Ethernet communication between the inverter and other devices.
Description
LED status
OFF Power-OFF/initializing
Blinking green No connections established with the master
Green Connections established with the master
OFF Power-OFF / inverter reset
Solid green Operating properly
Red Fault detected
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
Remarks
2. Ethernet Communication
2.12 PROFINET
1
2
3
4
5
6
7
8
9
10
113