2.12
PROFINET
2.12.1 Outline
PROFINET is available only for the FR-E800-EPB and the FR-E800-SCEPB.
When the PROFINET communication operation is performed through the Ethernet connector on the inverter, data transmission
is enabled for parameters, command data, and feedback data between a master and slaves.
Some functions are not supported depending on the date of manufacture of the inverter. For details of specification changes,
refer to
page
220.
Communication specifications
The communication specification varies depending on the specification of the master.
Item
Category
100BASE-TX
Transmission speed
100 Mbps (10 Mbps is not supported.)
Maximum number of
No upper limit on the same Ethernet network
branches
Number of cascade
Maximum: 2
connection stages
Ethernet cable
Connection cable
(IEEE 802.3 100BASE-TX compliant cable or ANSI/TIA/EIA-568-B (Category 5e)
compliant shielded 4-pair branched cable)
Topology
Line, star, or a combination of line and star
PROFINET
communication
PROFINET IO Device V2.35
specifications
Operation status LEDs
LED name
NS
Communication status
MS
Inverter status
LINK1
Connector for communication (PORT1) status
LINK2
Connector for communication (PORT2) status
GSDML file
A GSDML file is available for download.
Model
FR-E800-E
PROFINET
FR-E800-SCE
FR-E800-SCE
PROFINET + PROFIsafe
Description
OFF
Blinking green
Green
OFF
ON (green)
Red
OFF
Blinking green
Solid green
OFF
Blinking green
Solid green
Classification
GSDML-V2.35-MitsubishiElectric-FR-E800-E-[yyyymmdd].xml
GSDML-V2.35-MitsubishiElectric-FR-E800-SCE-[yyyymmdd].xml
Description
LED status
Power-OFF / during inverter reset
No connections established with the master
Connections established with the master
Power-OFF / during inverter reset
Operating properly
Fault detected
Power-OFF/link-down
Link-up (Data reception in progress)
Link-up
Power-OFF/link-down
Link-up (Data reception in progress)
Link-up
GSDML file
Remarks
2. Ethernet Communication
2.12 PROFINET
1
2
3
4
5
6
7
8
9
10
149