Ethernet/Ip; Outline; Initial Setting For Ethernet/Ip - Mitsubishi Electric 800 Series Instruction Manual

2.11

EtherNet/IP

2.11.1 Outline

When the EtherNet/IP communication operation is performed through the Ethernet connector on the inverter, data such as
parameters, command values, and feedback values are regarded as objects used for data communication between a master
and slaves. Objects consist of the Class ID, object name, data type, access rule, etc. I/O message communication (cyclic) and
explicit message communication (acyclic) are available.
 Communication specifications
The communication specification varies depending on the specification of the master.
Item
Maximum number of
No upper limit on the same Ethernet network
branches
Ethernet cable
Connection cable (IEEE 802.3 100BASE-TX/10BASE-T compliant cable or ANSI/TIA/EIA-568-B
(Category 5e) compliant shielded 4-pair branched cable)
 Operation status LEDs
LED name Description
NS Communication status
MS Inverter status
LINK1 Connector for communication (PORT1) status
LINK2 Connector for communication (PORT2) status
 EDS file
An EDS file is available for download.
Mitsubishi Electric FA Global Website:
www.MitsubishiElectric.co.jp/fa
For details, contact your sales representative.
NOTE
• The EDS file is used in configuration software. To install the EDS file properly, refer to the instruction manual of your
configuration software.

2.11.2 Initial setting for EtherNet/IP

Use the following parameters to perform required settings for Ethernet communication between the inverter and other devices.
Description
LED status
OFF Power-OFF / IP address not set
Blinking green Online, no connections established
Solid green Online, connections established
Blinking red Connection timeout
OFF Power-OFF / inverter reset
Blinking green No connections established
Solid green Operating properly
Blinking red Warning or alarm output
Solid red Fault detected
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
OFF Power-OFF/link-down
Blinking green Link-up (Data reception in progress)
Solid green Link-up
Remarks
2. Ethernet Communication
2.11 EtherNet/IP
1
2
3
4
5
6
7
8
9
10
99