Table of Contents
Advertisement
7
Troubleshooting and Tips
V
CAUTION!
Follow the safety instructions in the manual "Safety notes and other
important information" and in chapter
page
31.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
7.1
Power On Indicator Remains Unlit
The power on indicator remains unlit after switching on:
Power cable incorrectly connected
Ê Make sure that the power cable is correctly connected to the server and to
the grounded socket.
Power supply overloaded
Ê Disconnect the server power plug from the power socket.
Ê Wait a few seconds before you plug it into the grounded socket again.
Ê Switch on your server.
TX150 S5
"Hardware Installation" on
Operating Manual
79
Advertisement
Table of Contents
