Troubleshooting (Initial Setup By Selecting "Wps") - Panasonic HomeHawk WINDOW Information And Troubleshooting Manual

T
roubleshooting (Initial setup by selecting "WPS")
What is WPS?
WPS is a function of wireless routers that is used to easily connect wireless devices to wireless routers.
A WPS button on a wireless router indicates that it has the WPS function. (Depending on the type of wireless
router‚ the WPS function may be disabled on the wireless router even if there is a WPS button.)
If you have trouble during the initial setup‚ check the following causes/solutions fi rst.
Problem LED color
When initial setup The camera's
is performed LED indicator is
using WPS‚ the blinking in red.
following screen is
displayed and the
setup cannot be
completed.
18
Cause Solution
If the LED indicator is blinking in red‚ unplug the camera and then plug
it in again‚ check the following causes and solutions‚ and then try again
from the beginning.
The WPS function on Some Internet Service Provider wireless routers
your wireless router may have WPS disabled.
may be disabled.
• During initial setup select "Bluetooth".
The camera and • Move the camera and wireless router closer
wireless router are too together.
far away.
The wireless router is • Press the WPS button on the wireless router
not in WPS mode. for long enough until the LED indicator on the
router starts blinking.
Several cameras are • Only 1 camera can be operated in WPS mode
in WPS mode. at a time.
The DHCP function of • Confi rm that the wireless router's DHCP settings
your wireless router are enabled. Refer to your wireless router's
may be disabled. manual.
The address fi lter • Register the MAC address (page 5) of the
function of your camera to the address fi lter setting of the
wireless router may wireless router. Refer to your wireless router's
be enabled. manual.