Panasonic HomeHawk WINDOW Information And Troubleshooting Manual page 19

Problem LED color
When initial setup The camera's LED
indicator is lit in
is performed
yellow.
using WPS‚ the
following screen is
displayed and the
setup cannot be
The camera's LED
completed.
indicator is lit in
blue.
Cause Solution
The camera is not in • Follow the on-screen instructions‚ and press
WPS mode. and hold the
SETUP
until the LED indicator starts blinking (about 5
The button
seconds).
was not pressed for
long enough.
The WPS button was • Reconnect your mobile device to the router
pressed on another whose WPS button was pressed‚ restart the
HomeHawk
[
router which is
different from the screen instructions.
router your mobile
device is connected
with.
A network clash has • Unplug all the wireless routers and plug them
occurred because in again.
you have 2 wireless If the situation still does not improve‚ refer to
routers at home that your wireless router's manual for information
are using the same on how to change the router channel of your
channel or channels wireless network.
of a close frequency.
The "Isolation" • Sometimes when the "Isolation" function
function on the is enabled‚ the camera will not be able to
wireless router is communicate with your mobile device via
enabled. your wireless router. Disable the "Isolation"
function on your wireless router. For details‚
refer to your wireless router's manual.
SETUP
button on the camera
]
app‚ and then follow the on-
19