Initial Setup (For Camera) - Panasonic KX-HNC805C Installation Manual

Setup
Initial setup (for
camera)
Confirm the following before you
begin.
– Make sure you have installed
the [Home Network] app on
your mobile device
– Make sure the camera and your
wireless router are turned on
and the camera's LED indicator
is lit in yellow
– Make sure the camera is
located within range of your
wireless router
– Make sure your mobile device
is connected to your wireless
router
– Make sure your mobile device
can connect to the Internet
– Make sure you know the
network name (SSID) and
password assigned to your
wireless router
18
HNC805C_(en-en)_0420_shinsei.pdf
For assistance, visit www.panasonic.ca/english/support
18
Initial setup (for iPhone, iPad
users)
Do not perform this procedure if
you want to integrate the
camera with your Home
Network System. Use the
procedure on page 22.
1
Press and hold the reset
button on the back of the
camera for about 10 seconds,
and then wait for the camera's
LED to light in yellow.
R The camera's setting will be
reset.
2
Start the [Home Network]
app.
3
Tap [Set up the HD Camera].
4
When prompted, press the
MWi-Fi SETUPN button on the
camera, and then tap [Next].
R The LED indicator blinks in
yellow.
5
Change your mobile device's
Wi-Fi setting temporarily so
that it connects to the camera
directly.
R Open your mobile device's
[Settings] app, tap [Wi-Fi],
select
"KX-HNC800_Panasonic",
enter "00000000" as the
password, and then tap
[Join].
2016/04/20 16:55:32