Table of Contents
Advertisement
Installing the Tracer™ TD-5 Display
This section describes installation procedures when
mounting the Tracer™ TD-5 display near the RTRM
module or remotely mounted up to 328 ft (100 m) by using
a field-supplied 75 mm VESA mounting bracket. Read and
observe all warning and caution statements before you
begin the installation procedure.
WARNING
Hazardous Voltage!
Failure to disconnect power before servicing could
result in death or serious injury. Disconnect all electric
power, including remote disconnects before servicing.
Follow proper lockout/tagout procedures to ensure the
power can not be inadvertently energized.
Packaged Contents
•
One (1) Tracer™ TD-5 display with permanently
attached 2.6 ft (0.8 m) power cable with male connector
•
Four (4) M-4 screws
•
Four (4) spacer washers
Additional Mounting Parts
•
TD-5 Display Low Profile Mounting Bracket (VESA
75mm) (PN: X05010511010)
Installing the TD-5 Display onto a
VESA Mounting Bracket
The Tracer™ TD-5 can be mounted near the RTRM module
in the control panel, or remotely mounted up to 328 ft
(100 m) by using a field-suppled 75 mm VESA mount.
Remote mounting requires the following additional field-
supplied components:
•
A power source that will supply 24 VAC to the display
•
Power cables
Many commercial 75mm VESA mounting brackets are
available, which range from a simple wall mount to tilt-
and-swivel mounts such as the one shown in
p.
10, or the TD-5 Display Low Profile Mounting Bracket
(VESA 75mm) (PN: X05010511010).
To install onto a VESA mounting bracket:
1. Disconnect power at the circuit breaker and perform
lockout/tagout procedures.
2. Mount the VESA mounting bracket according to
manufacturer's instructions.
3. Position the TD-5 display
2
bracket
and align the four mounting holes with the
bracket while inserting and hand-tightening the four
M-4 screws. (Some brands of VESA mounting brackets
RT-SVX49C-EN
Figure 2,
1
onto the VESA mounting
may require the use of the four spacer washers to allow
the M-4 screws to tighten properly.)
4. Securely tighten the M-4 screws using a Phillips
screwdriver.
9
Hide quick links:
Advertisement
Table of Contents
