Installing the Tracer TD7 Display
This section describes installation procedures when installing the Tracer TD7 display inside a Trane
large enclosure, using a VESA mounting bracket, using the TD7 Display Portable Carry Case
(available as a separate purchase). Read and observe all warning and caution statements before
you begin the installation procedure.
The TD7 display can also be mounted remotely up to 328 ft. (100 m.) from the UC600 by using a
field-supplied VESA mounting bracket (see
Bracket," p.
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
Packaged Contents
•
•
•
•
•
•
Additional Mounting Parts
•
•
•
12
15).
One (1) Tracer TD7 display with permanently attached 3.3 ft (1.0 m.) power cable with male
connector (PN: X13760335-01)
Four (4) M-4 screws
Four (4) spacer washers
Two (2) 2-pin terminal blocks (one spare)
One (1) 7 ft. (2.24 m.) category 5E Ethernet cable for indoor use
One (1) 3.3 ft. (1 m.) power cable with female connector (PN: X19051625020)
TD7 Display Low Profile Mounting Bracket (VESA 75mm) (PN: X05010511010)
TD7 Display Portable Carry Case (PN: X18210613010)
Sealed Ethernet cable (PN: X19070632020)
"Installing the TD7 Display onto a VESA Mounting
WARNING
Hazardous Voltage!
BAS-SVX50F-EN