Weider WESY85290 User Manual page 8

8. Press a 1 3/4Ó Square Inner Cap (44) into the
top of a Press Arm (46). Wet the handle on
the Press Arm with soapy water. Slide a
Handgrip (31) onto the handle. Press a 1Ó
Round Inner Cap (49) into the other end of
the handle. Attach the Press Arm to one side
of the Press Frame (17) with two 5/16Ó x 2 1/2Ó
Bolts (22) and two 5/16Ó Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
9. Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded bracket
on each Arm. Arm identification is very
important for step 10.
Attach a ÒVÓ-Pulley (6) and a Long Cable Trap
(50) to the Right Arm (48) with a 3/8Ó x 2 1/2Ó
Bolt (7) and a 3/8Ó Nylon Locknut (21).
Attach a ÒVÓ-Pulley (6) and a Long Cable Trap
(50) to the Left Arm (47) with a 3/8Ó x 2 1/2Ó
Bolt (7) and a 3/8Ó Nylon Locknut (21).
10. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 9
to identify the Right Arm. Be sure that the
upper end of the Right Arm is behind the
indicated bracket on the Top Frame (55).
Tap two 1Ó Retainers (69) and a 1Ó Round
Cover Cap (70) onto the right axle. Be sure
that the teeth on the Retainers bend
toward the Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4Ó Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10Ó Pad (45) onto the
lower end of each Arm.
8
44
49
46
9
Welded
Brackets
48
10
48
44
45
8
31
22
3
17
50
50
7
6
6
21
55
Bracket
Lubricate Axle
69
70
45
55
44
49
46
47
47
69
70