Weider 8530 User Manual page 11

17. Route the Medium Cable (58) around the
3 1/2" Pulley (15) attached to the bracket on
the Top Frame (55). Tighten the 3/8" x 2" Bolt
(12) and the 3/8" Nylon Locknut (21). (Note:
This Pulley is pre-assembled. It has been
shown disassembled for easy part identifica-
tion.) Be sure that the Cable is in the
groove of the Pulley and that the Cable
and Pulley move smoothly.
18. Remove the 3 1/2" Low Pulley (95) from the
Press Frame (17). Reattach the Pulley with
the 5/8" x 9/16" Spacer (7) between the
Pulley and the Press Frame. Hand-tighten
the 3/8" Nylon Locknut (21).
Locate the Short Cable (23). Route the
Short Cable under the 3 1/2" Low Pulley (95).
Be sure that the end of the Cable with the
ball is on the indicated side of the Press
Frame (17) and that the Cable is between
the Pulley and the crossbar on the Press
Frame. Tighten the 3/8" Nylon Locknut (21)
and 3/8" x 3 3/4" Bolt (88).
Route the Short Cable (23) around the 3 1/2"
Pulley (15) attached to the lower hole in the
Front Upright (42). Be sure that the Cable
Trap (not shown) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the
3/8" Nylon Locknut (21) and 3/8" x 3 3/4" Bolt
(not shown).
19. Route the Short Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is in the "3 o'clock" position and
that the Cable is routed around the Pulley
as shown. Tighten the 3/8" Nylon Locknut
(21) and 3/8" x 3 1/2" Bolt (not shown).
Route the Short Cable (23) around the 3 1/2"
Pulley (15) attached to the upper hole in the
Front Upright (42). Be sure that the Cable
Trap (not shown) is turned to hold the
Cable in place and that the Cable is routed
around the Pulley as shown. Tighten the
3/8" Nylon Locknut (21) and 3/8" x 3 3/4" Bolt
(not shown).
20. Attach the end of the Short Cable (23) to the
Long "U"-Bracket (57) with a 1/4" Nylon
Locknut (2) and a 1/4" Flat Washer (10). Do
not tighten the 1/4" Nylon Locknut. It
should be threaded onto the Cable only a
couple of turns.
17
55
Bracket
21
18
21
42
17
19
15
21
42
17
20
2
10
11
12
15
58
23 9
15
88
Ball
21
Crossbar
15
23
21
66
12
9 3
6
57
23
7
95