Table of Contents
Advertisement
11. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Be careful not to confuse the Right Arm
with the Left Arm (47); note the position of
the “V” Pulley (50) to identify the Right
Arm. Be sure that the upper end of the
Right Arm is behind the indicated bracket
on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round
Cover Cap (70) onto the axle. Be sure that
the teeth on the Retainers bend toward the
Round Cover Cap, as shown in the inset
drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Inner Caps (44) into the lower
ends of the Left and Right Arms (47, 48). Wet
the lower end of each Arm with soapy water.
Slide a 10” Pad (45) onto the lower end of
each Arm.
12. Press two 1” x 2” Inner Caps (87) into the
indicated end of the Squat Arm (84).
Attach the Squat Arm (84) to the VKR Upright
(74) with a 3/8” x 5 1/2” Bolt (93) and a 3/8”
Nylon Locknut (21). Be sure that the indicat-
ed bracket is pointing down as shown.
Wet the ends of the Squat Arm (84) with
soapy water. Slide the two Squat Arm Pads
(85) onto the Squat Arm.
Attach a Handle (82) to one side of the Squat
Arm (84) with a 5/16” x 2 1/2” Bolt (22), two
5/16” Flat Washers (8), a 1/2” x 17/32” Spacer
(91), and a 5/16” Nylon Locknut (3).
Wet the Handle (82) with soapy water. Slide a
5” Plastic Grip (83) onto the Handle. Press a
1” Round Inner Cap (49) into the other end of
the Handle.
Assemble another Handle (82) to the other
side of the Squat Arm (84) in the same man-
ner.
11
55
Bracket
47
Axle—
Lubricate
50
69
70
45
44
48
44
55—Axle
45
69
70
12
22
83
85
82
87
49
8
82
91
3
85
84
21
Bracket
93
74
Page 9
Hide quick links:
Advertisement
Table of Contents
