Weider 831.15791.3 User Manual page 9

11. Attach a Fly Arm (25) to an Upright (1) with an
M10 x 120mm Bolt (19) and an M10 Nylon
Locknut (33). Make sure that the Fly Arm is on
the outside of the Fly Arm Stop (15). Do not
overtighten the Nylon Locknut; the Fly Arm
must pivot easily.
Attach the other Fly Arm (25) in the same way.
12. Insert an Arm Pad Tube (12) into the indicated
hole in a Fly Arm (25) from the side shown. Next,
slide a Foam Pad (23) onto the Arm Pad Tube;
the Foam Pad will hold the Arm Pad Tube in
place.
Repeat this step with the other Fly Arm (not
shown).
13. Insert the Inner Bar (43) into the Outer Bar (40)
and align the indicated holes. Using a hammer,
tap the two Roll Pins (41) into the holes until they
are flush with the Outer Bar.
14. Attach the Curl Pad (45) to the Curl Post (27) with
two M6 x 16mm Screws (29).
15. Make sure that all parts are properly tightened
before the weight bench is used. Note: Some
hardware may be left over after assembly is com-
pleted. The use of all remaining parts will be
explained in ADJUSTMENT, starting on page 10.
11
25
19
12
25
23
13
41
40
14
45
9
33
1
15
25
12
43
Holes
Holes
41
29
27