Remove Cable Chains - Fujitsu ETERNUS AB Series Maintaining Hardware

Hide thumbs Also See for ETERNUS AB Series:
Table of Contents

Advertisement

You can perform the replace procedure while the drive drawer is online, because the Set Drawer
Service Action Allowed Indicator CLI command completed successfully.
If you are replacing a drawer in a controller shelf without Drawer Loss Protection:
a. Turn off both power switches on the controller shelf.
Wait for all LEDs on the controller shelf to go dark.
If you are replacing a drawer in an expansion drive shelf without Drawer Loss Protection:
a. Turn off both power switches on the controller shelf.
b. Wait for all LEDs on the controller shelf to go dark.
c. Turn off both power switches on the drive shelf.
Wait two minutes for drive activity to stop.
What to do next
Go to
Remove cable

Remove cable chains

You remove both cable chains so you can remove and replace a failed drive drawer. The left and right cable
chains allow the drawers to slide in and out.
Before you begin
• You have issued the Set Drawer Attention Indicator CLI command, or you have stopped host I/
O activity and powered off the drive shelf and controller shelf.
• You have an ESD wristband, or you have taken other antistatic precautions.
• You have a flashlight.
About this task
Each drive drawer has left and right cable chains. The metal ends on the cable chains slide into corresponding
vertical and horizontal guide rails inside the enclosure, as follows:
• The left and right vertical guide rails connect the cable chain to the enclosure's midplane.
• The left and right horizontal guide rails connect the cable chain to the individual drawer.
Attention: Possible hardware damage — If the drive tray is powered on, the cable chain is energized
until both ends are unplugged. To avoid shorting out the equipment, do not allow the unplugged
cable chain connector to touch the metal chassis if the other end of the cable chain is still plugged in.
Procedure
1. From the rear of the drive shelf, remove the right fan canister:
a) Press the orange tab to release the fan canister handle.
The figure shows the handle for the fan canister extended and released from the orange tab on the
left.
chains.
 |  Drives  |
53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus hb seriesEternus hb5000Eternus hb2000

Table of Contents