Complete Drive Replacement (60-Drive) - Fujitsu ETERNUS AB Series Maintaining Hardware

Hide thumbs Also See for ETERNUS AB Series:
Table of Contents

Advertisement

Raised button on the right side of the drive carrier
3. Lower the drive straight down, and then rotate the cam handle down until the drive snaps into place under
the orange release latch.
4. Carefully push the drive drawer back into the enclosure. Push the drawer in slowly to avoid jarring the
drawer and causing damage to the storage array.
5. Close the drive drawer by pushing both levers towards the center.
The green Activity LED for the replaced drive on the front of the drive drawer comes on when the drive is
inserted correctly.
Depending on your configuration, the controller might automatically reconstruct data to the new drive. If
the shelf uses hot spare drives, the controller might need to perform a complete reconstruction on the hot
spare before it can copy the data to the replaced drive. This reconstruction process increases the time that
is required to complete this procedure.
What to do next
Go to
Complete drive replacement

Complete drive replacement (60-drive)

You complete the drive replacement to confirm that the new drive is working correctly.
Procedure
1. Check the Power LED and the Attention LED on the drive you replaced. (When you first insert a drive, its
Attention LED might be on. However, the LED should go off within a minute.)
• Power LED is on or blinking, and the Attention LED is off: Indicates that the new drive is working
correctly.
• Power LED is off: Indicates that the drive might not be installed correctly. Remove the drive, wait 30
seconds, and then reinstall it.
• Attention LED is on: Indicates that the new drive might be defective. Replace it with another new drive.
2. If the Recovery Guru in SANtricity System Manager still shows an issue, select Recheck to ensure the
problem has been resolved.
3. If the Recovery Guru indicates that drive reconstruction did not start automatically, start reconstruction
manually, as follows:
Note: Perform this operation only when instructed to do so by technical support or the Recovery Guru.
(60-drive).
 |  Drives  |
50

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus hb seriesEternus hb5000Eternus hb2000

Table of Contents