Fujitsu ETERNUS AB Series Maintaining Hardware page 48

Hide thumbs Also See for ETERNUS AB Series:
Table of Contents

Advertisement

• You have reviewed the
About this task
When you remove a drive from an HB5200 controller shelf or a DE460C drive shelf, you must lift the drive
partly out of the drawer and wait for the drive to spin down. Then, you can remove the drive completely.
Procedure
1. Unpack the replacement drive, and set it on a flat, static-free surface near the shelf.
Save all packing materials for the next time you need to send a drive back.
2. Release the drive drawer levers from the center of the appropriate drive drawer by pulling both towards the
sides of the drawer.
3. Carefully pull on the extended drive drawer levers to pull out the drive drawer to its full extension without
removing it from the enclosure.
4. Gently pull back the orange release latch that is in front of the drive you want to remove.
The cam handle on the drive springs open partially, and the drive is released from the drawer.
Orange release latch
5. Open the cam handle, and lift out the drive slightly.
6. Wait 30 seconds.
7. Use the cam handle to lift the drive from the shelf.
Requirements for handling drives
topic.
 |  Drives  |
48

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus hb seriesEternus hb5000Eternus hb2000

Table of Contents