Fujitsu ETERNUS AB Series Maintaining Hardware page 56

Orange ring on vertical guide rail
b) To unlatch the cable chain, insert your finger into the orange ring and press towards the middle of the
system.
c) To unplug the cable chain, carefully pull your finger toward you approximately 1 inch (2.5 cm). Leave
the cable chain connector within the vertical guide rail. (If the drive tray is powered on, do not allow
the cable chain connector to touch the metal chassis.)
5. Disconnect the other end of the cable chain:
a) Using a flashlight, locate the orange ring on the end of the cable chain that is attached to the
horizontal guide rail in the enclosure.
The figure shows the horizontal connector on the right and the cable chain disconnected and partially
pulled out on the left side.
Orange ring on horizontal guide rail
b) To unlatch the cable chain, gently insert your finger into the orange ring and push down.
The figure shows the orange ring on the horizontal guide rail (see item 1 in the figure above), as it is
pushed down so that the rest of the cable chain can be pulled out of the enclosure.
c) Pull your finger toward you to unplug the cable chain.
6. Carefully pull the entire cable chain out of the drive shelf.
7. Replace the right fan canister:
a) Slide the fan canister all the way into the shelf.
b) Move the fan canister handle until it latches with the orange tab.
c) If the drive shelf is receiving power, confirm that the amber Attention LED on the back of the fan is not
illuminated and that air is coming out the back of the fan.
Cable chain, partially removed
Cable chain, partially removed
| Drives |
56