Cable Connections And Pin Assignments - Siemens SCD 1898-I Instruction Manual

01.02
3.3

Cable Connections and Pin Assignments

The LCD monitor has been tested and set-up in the factory.
• Before use, the power supply and the VGA signals should be connected to the
sockets provided. Connections to the monitor should adhere to
EMC regulations.
A high-quality 75-ohm coaxial cable must be used for the VGA-signals.
Low quality cables can result in interference and shadowing on the display.
VGA Interface
The VGA interface is a standard 15-pin male HD-D-type connector.
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Power Supply
Power is supplied to the SCD 1898 I/IT LCD monitor via a standard power
connector on the rear of the unit.
High-Resolution 18" LCD Monitors SCD 1898-I/IT
A5E00120696
Signal
Video input RED
Video input GREEN
Video input BLUE
Not used
Not used
GND (RED)
GND (GREEN)
GND (BLUE)
Not used
GND
Not used
Not used
H-Sync.
V-Sync.
Not used
Instruction manual
25