Utilities - Siemens SCD 1898-I Instruction Manual

Instruction manual
4.4.10

Utilities

Various settings are available here to control the behaviour and testing of the
monitor.
User Settings
Six possibilities are available in this sub menu, as follows:
Value
OSD Horz Position
OSD Vert Position
OSD Background
User Timeout
DPMS
Auto Source Select
Gamma Adjust
Notice
This adjustment should only be carried out by qualified personnel.
This function allows the "gamma curve" to be adjusted in 32 steps, i.e., the
incoming color values are modified by a particular factor and passed on to the
display.
One of the 32 points can be selected from an index. The output values for red,
green and blue can then be set for the selected point. A linear interpolation occurs
between the 32 points.
Test Pattern
This causes a staircase in red, green, blue and grey to be displayed on the screen
for test purposes.
Reset to factory defaults
This function causes all settings to return to the factory default values.
32
Function
Horizontal position of the OSD on the display
Vertical position of the OSD on the display
Adjust the OSD background.
Translucent
Opaque
This allows the time which elapses between the last key
press and the disappearance of the OSD to be set.
Settings between 5 and 50 seconds in steps of
5 seconds are allowed.
Activates/deactivates the power management.
• If the DPMS is active then the monitor switches off
automatically when there is no sync. signal, i.e., the
screen goes dark. Before it switches off, a "NO
signal" message appears on the screen.
• If the DPMS is not active then the "NO signal"
message stays on the screen until a valid video
signal is applied to the monitor.
This has no function
High-Resolution 18" LCD Monitors SCD 1898-I/IT
= transparent
= not transparent
A5E00120696
01.02