01.02
4
Operation and Alignment
This chapter contains a description of all the operating and alignment functions.
4.1
Location of the Operation and Alignment Controls
All controls are located beneath the display and are used to navigate in the OSD
menu. Only the power switch is on the rear of the unit.
4.2
Aligning the Converter
Since there are no standards for video output signals from VGA cards, the first time
the unit is switched on it will automatically adjust itself to the graphic card currently
being used.
Note
The adjustment procedure can also be called up by pressing first the + and then
the – key.
4.3
OSD Menu
The "On Screen Display" (OSD) is a menu system which is displayed on the
screen. It allows all the monitor functions to be adjusted. Only the four keys are
necessary for operating the OSD.
These keys and the OSD menu enable the LCD monitor converter card to be
adjusted. The four keys are used to navigate through the menus and to select and
adjust parameters.
The control keys have the following functions:
UP
This key has two functions:
• Activates a sub menu function selected by the SUB key,
• Increases the value of the currently selected parameter, e.g., brightness.
DOWN
• Reduces the value of the currently selected parameter, e.g., brightness.
High-Resolution 18" LCD Monitors SCD 1898-I/IT
A5E00120696
Menu
Menu
DOWN
-
UP
+
Enter
SUB
Instruction manual
27