Siemens SCD 1898-I Instruction Manual page 32

Instruction manual
Normal Scaling Modes
There are three possible values for this menu point, with the following functions:
Value
One to One
Fill Screen
Fill to Aspect Ratio
Non Linear Scaling Parameters
In this sub menu point there are three possible settings each for the horizontal and
vertical sizes allowing the picture height and width to be adjusted independently:
Value
Horiz Clipping
Horiz Offset
Horiz Stretch
Vert Clipping
Vert Offset
Vert Stretch
30
Function
This setting causes the picture to be displayed without
expanding or contracting it.
If the picture has a lower resolution than the display
then a black frame will appear.
If the picture has a greater resolution than the display
then only the top left-hand corner of the picture will
appear.
This setting causes the picture to fill the entire display
This setting expands the picture as much as possible
while maintaining the height to width ratio of the original
image.
Function
Horizontal expansion of the picture
Horizontal shifting only if the picture width, set by the
horizontal clipping, is larger than the displayable picture
width.
This is a horizontal linearity setting for the picture width,
i.e., if the value is negative, the picture is compressed
more at the horizontal edges and stretched more in the
middle.
A positive value has the opposite effect.
Vertical expansion of the picture.
Vertical shifting only if the picture height, set by the
vertical clipping, is larger than the displayable picture
height.
This is a vertical linearity setting for the picture height,
i.e., if the value is negative, the picture is compressed
more at the vertical edges and stretched more in the
middle.
A positive value has the opposite effect.
High-Resolution 18" LCD Monitors SCD 1898-I/IT
01.02
A5E00120696